Codesys Sfc Example Apr 2026

Transition from Step 20: Condition: (T#45s) AND NOT EStop_Pressed Supervisory Logic (Parallel Branch): IF EStop_Pressed THEN Jump to Step 99: EMERGENCY_RETRACT END_IF

But then... nothing.

She added a parallel to the main sequence: codesys sfc example

Lena pointed at the HMI. "No. The SFC saved it. Look—step history."

15:47:32.100 - Enter Step 20 (DIP) 15:47:32.105 - Timer started: 45s 15:48:17.200 - Temp fault detected 15:48:17.205 - Exit Step 20 15:48:17.210 - Enter Step 99 (EMERGENCY_RETRACT) 15:48:21.400 - Acid level <5% 15:48:21.405 - Enter Step 0 (IDLE) The coil was perfect. The acid was safe. And Lena finally understood the power of SFC in CODESYS: Transition from Step 20: Condition: (T#45s) AND NOT

At 3:47 PM, a bearing seized on the acid bath agitator. The temperature spiked to 110°C. Acid_Temp > 95C triggered a pre-programmed fault.

This is how industrial programmers think. Not just "code that runs"—but . The acid was safe

Acid_Drain_Valve := FALSE; // Reset only when safe Emergency_Alerter := FALSE; Three weeks later, the line went live.

In CODESYS SFC, she right-clicked Step 20 and selected . She created an Action named Acid_Emergency . She set its qualifier to N (Non-Stored, executes while step is active) and S (Set/Stored for emergency).

Lena shook her head. "No. We need an SFC." She opened CODESYS and created a new POU (Program Organization Unit). She chose Sequential Function Chart (SFC) . No ladder. No structured text loops. Just pure, visual, time-tested sequence logic.

The Pickle Paradox System: Industrial Pickling Line (Acid Bath for Steel Coils) Controller: CODESYS SoftPLC v3.5 SP20 Part 1: The Problem Engineer Lena Vasquez stared at the production log. Line 7, the steel coil pickling line, had just scrapped its third $40,000 coil of the week. The sequence: Load coil → Dip in HCl acid → Rinse → Dry → Unload .