Dell Mih61r Mb Front Panel Pinout -

There isn't one. Dell does not route a reset button to the front panel header on the MH61R. If you want a reset button, you must short two specific pins on the super I/O chip—which is not recommended for beginners. The "Dell Trap" Explained Why does your standard case power switch not work?

Press F1 to continue, or flash a modified BIOS (risky) or simply short the two sensor pins together (Pin 8 and Pin 9 in some revisions—research your specific board first). Final Verdict The Dell MH61R is a perfectly capable LGA1155 board (supports Ivy Bridge i5/i7), but it was designed to be e-waste, not upgraded. By understanding the pinout—specifically that the power switch uses Pins 6 & 7 instead of 6 & 8—you can resurrect this board in any case. Dell Mih61r Mb Front Panel Pinout

| Pin Number | Signal | Description | Standard Intel Equivalent | | :--- | :--- | :--- | :--- | | 1 | HDD LED + | Hard Drive Activity (Anode) | Pin 1 | | 2 | HDD LED - | Hard Drive Activity (Cathode) | Pin 3 | | 3 | GND | Ground | Pin 2 or 4 | | 4 | PWR LED + | Power LED (Anode - Green) | Pin 2 (Usually) | | 5 | PWR LED - | Power LED (Cathode) | Pin 4 | | 6 | PWR_SW | | Pin 6 (Usually) | | 7 | GND | Ground for Power Button | Pin 8 (Usually) | | 8 | NC | Not Connected (Key pin on Intel) | Pin 5 (Missing on Intel) | | 9 | +5V (Standby) | 5V always on | N/A | | 10 | GND | Aux Ground | N/A | There isn't one

You have a Dell OptiPlex 3010, 7010, or 390. The motherboard is the (often labeled CN-0Y8H8Y or similar). You decided to move this motherboard into a standard ATX case to save money, or perhaps you are trying to diagnose a power button failure. The "Dell Trap" Explained Why does your standard

Let's tear down the schematic, identify the pins, and get your machine booting. On most standard motherboards (Asus, MSI, Gigabyte), the front panel header is a block of 9 pins (missing one for keying). Dell, however, uses a 10-pin or 12-pin header layout that redefines everything.

If you are reading this, you have likely just experienced a specific flavor of PC building frustration.

On the MH61R, look for a header labeled or simply FRONT PANEL . It is located near the bottom right edge of the board, usually just above the SATA ports.