8080 Manual: Siemens Siwamat

Operational Guide and Technical Manual Analysis: The Siemens Siwamat 8080 Washing Machine

| Problem | Probable Cause (from manual) | Solution | | :--- | :--- | :--- | | Machine does not start | Door not fully closed, power cord unplugged, start button not pulled out. | Push door firmly until click; check mains; pull start button. | | Machine vibrates heavily | Transit bolts still installed. | Remove transport screws from rear panel. | | Water not draining | Kinked drain hose or blocked filter. | Straighten hose; clean bottom filter. | | Detergent residue on clothes | Low-sudsing powder not used; too much detergent. | Use less detergent; run an empty hot cycle to clear residue. | | Drum does not turn | Belt slipped off (after many years). | Service required – manual warns not to open rear panel without training. | siemens siwamat 8080 manual

| Program | Max Temp | Cycle Duration (Normal) | Typical Use | | :--- | :--- | :--- | :--- | | Cotton / White | 95°C | 135 min | Sheets, towels, heavily soiled whites | | Cotton / Colored | 60°C | 120 min | T-shirts, underwear | | Easy-Care | 60°C | 85 min | Polyester/cotton blends, shirts | | Delicates | 40°C | 50 min | Curtains, fine fabrics | | Wool | 30°C | 45 min | Machine-washable wool | | Drain/Spin | — | 10 min | Final spin only (800 RPM) | Operational Guide and Technical Manual Analysis: The Siemens

The manual emphasizes the removal of transit bolts. Four transport securing screws (located at the rear panel) must be unscrewed and replaced with the supplied cover caps. Failure to do so results in severe vibration and permanent damage to the drum suspension. | Remove transport screws from rear panel