base { log_debug = off; log_info = on; daemon = on; redirector = iptables; } redsocks { local_ip = 192.168.88.2; local_port = 12345; ip = 192.168.88.2; port = 1080; type = socks5; }
apt install redsocks /etc/redsocks.conf :
Example with redsocks (simpler):
Enable forwarding:
sysctl -w net.ipv4.ip_forward=1 iptables -t nat -A PREROUTING -i eth0 -p tcp -j REDIRECT --to-port 12345 Send specific traffic (or all) to the Linux box. Route all internet traffic via Linux box (policy routing): /ip route add dst-address=0.0.0.0/0 gateway=192.168.88.2 (Only if Linux box has its own default route to the real internet) Or use firewall marking (e.g., only for certain src/dst): /ip firewall mangle add chain=prerouting src-address=192.168.88.100/32 action=mark-routing new-routing-mark=via-v2ray /ip route add dst-address=0.0.0.0/0 gateway=192.168.88.2 routing-mark=via-v2ray Step 4 – NAT Consideration If the Linux box is on the same LAN, ensure MikroTik does not NAT traffic to it. Add a bypass rule: v2ray mikrotik
/tool sniffer quick ip-protocol=tcp port=1080 Check that packets reach the V2Ray proxy.
Here’s a technical write-up on integrating with MikroTik (RouterOS). This setup is commonly used to route traffic through a V2Ray proxy (e.g., VMess, VLESS, or Shadowsocks) from a MikroTik router, allowing entire networks to bypass restrictions or use encrypted tunnels. Write-Up: V2Ray + MikroTik Integration Objective Route LAN clients through a V2Ray proxy server using a MikroTik router as the gateway, without needing proxy software on each client. Limitations (Important) MikroTik RouterOS does not support V2Ray protocols natively (no VMess, VLESS, Trojan, etc.). Solution: Use an external device (Raspberry Pi, Linux VM, or container) as a transparent proxy bridge, or run V2Ray on a separate device and route traffic through it. base { log_debug = off; log_info = on;
On a LAN client, check public IP:
{ "inbounds": [ { "port": 1080, "protocol": "socks", "settings": { "auth": "no", "udp": true } } ], "outbounds": [ { "protocol": "vmess", "settings": { "vnext": [ { "address": "your-v2ray-server.com", "port": 443, "users": [{ "id": "uuid", "alterId": 0, "security": "auto" }] } ] } } ] } Run V2Ray: v2ray run -c config.json Install redsocks or iptables TPROXY to redirect traffic to V2Ray’s SOCKS5. Here’s a technical write-up on integrating with MikroTik