Wood Gasifier Builder--39-s Bible- Transform Tree Branches Into Apr 2026

Your job as a builder is to maintain that zone. Too wide, and you lose heat. Too narrow, and you choke airflow. The “Bible” method: Start with a 4-inch throat for a 10 kW generator. Taper it by welding a stainless steel cone. It’s crude, but it works. Raw wood gas carries tar and ash. Tar will gum valves and rings in under ten hours. Ash will score cylinder walls.

A gasoline engine expects vaporized liquid fuel. Wood gas is dry and has a different air-to-fuel ratio (about 1.2:1 by volume, compared to gasoline’s 14.7:1).

“I felt like a caveman,” he says. “Digging a hole to bury gold.”

John McGrath, a homesteader in the Appalachian foothills, had spent three days clearing storm-damaged oak from his back forty. The trunk went to the sawmill. The branches—tons of them—went into a smoldering, smoky burn pile. That night, watching the news report on diesel prices hitting $5.50 a gallon, he did the math. He was literally burning energy to get rid of energy. Your job as a builder is to maintain that zone

From the branch, a flame you cannot see. From that flame, the power to move mountains of stone. And from that power, freedom from the pump.

The Wood Gasifier Builder’s Bible is not a sacred text. It’s a stack of Xeroxed schematics, hand-drawn diagrams, and notes written in Sharpie on plywood. But it contains a truth that feels almost biblical:

When the next ice storm takes down power lines for a week, your generator runs on the branches that fell with the lines. When diesel hits $7 a gallon, your tractor doesn’t care. When the supply chain stutters, you look at the woodlot and see a full tank. The “Bible” method: Start with a 4-inch throat

It started with a clogged carburetor and a pile of slash.

John McGrath’s original “Bible” has now been scanned and shared online. A free PDF version, including dimensional drawings and parts lists for three different gasifier sizes, is available through the Open Gasifier Project.

Don’t modify the carburetor. Instead, build a “mixer” that fits between the air filter and the carb throat. It’s just a pipe with a venturi (a narrowing) and a needle valve to bleed in extra air. Raw wood gas carries tar and ash

Because branches are small, you can solar-kiln dry them in a $50 greenhouse frame. Clear plastic, pallet floor, ridge vent. Six weeks in summer. Three months in shoulder seasons. 2. The Heart of the Beast: The Reduction Zone Every gasifier has a narrowing, a throat, where charcoal glows at 1,800–2,000°F. This is where carbon dioxide turns into carbon monoxide—the actual fuel gas.

That was eight years ago. Today, John’s tractor runs on twigs. His backup generator hums on wood chips. And his “Wood Gasifier Builder’s Bible”—a dog-eared, grease-stained three-ring binder—contains the accumulated wisdom that turned a nuisance into a power plant.

You don’t need an oil well. You don’t need solar panels on a south-facing roof. You need branches. And the ancient, almost-forgotten technology of wood gasification. In the simplest terms, a wood gasifier is a chemical reactor that turns solid wood into a flammable gas. It does this not by burning the wood, but by cooking it in a low-oxygen environment—a process called pyrolysis.

Below 20% moisture. How to test? The “crack test.” Hit two pieces together. Dry wood makes a sharp, ringing crack. Wet wood thuds.